Beneath the terminal cover is found the compressor
relay (labeled "A" below), overload protector (labeled
"B") and the electrical terminals of the compressor
motor.
Remove the compressor relay by pulling it
straight off from the compressor.
Pull the wire off of the side terminal of
the relay. It is connected with a slip on connector. Firmly
pull the connector, do not pull on the wire. You may need
to use a pair of needle-nose pliers.
Inspect the connector for corrosion. If
it is corroded it should be cleaned or replaced.
Reattach the wire to the new compressor relay
and press the relay back onto the compressor terminals. Replace
the terminal cover box and plug in the refrigerator.
