The inlet switch is located on the
mounting plate, near the cam. The inlet switch sits on a thin
plastic or papery insulator and can be differentiated from the
holding switch which sits on a thick spacer. The inlet switch
also uses only two wires, while the holding switch uses three.
Remove the switch by removing the
two screws that hold it in place. The switch is connected by two
wires. Label the wire placement on the switch before disconnecting
the wires. The wires are connected to the switch with slip-on
connectors. Firmly pull the connectors off of the switch terminals
(do not pull on the wire). You may need to use a pair of needle-nose
pliers to remove the connectors. Inspect the connectors and the
terminals for corrosion. If the connectors are corroded they should
be replaced.
